Nano nightmare.

[Mousey]

I woke this morning to find my Nano in the middle of an update, it was still doing this an hour later, it rebooted and all seemed well until l decided to change channel, l now have loads of channels with 4 and 5 figure numbers, lots of duplicates and 99% of the channels don't work, the screen is showing 80% plus strength but nothing is playong on screeen.
Can anyone shed some light on what l need to do to restore my programmes please?

Cheers.

Alan.

[Andy_Hazza]

What you mean you woke up to find your nano in the middle of an update? What update?

[marty]

ABM? try scanning again

[Mousey]

The screen showed "Updating", thats all.

[Tomthumb]

version firmware in use??

[Larry-G]

Sounds like ABM was updating your channel list, presuming you have ABM setup as that and the EPG are the only two things that can update them selves in the image.

Although that said you have not even told us what image your using, so rite now we are just guessing which does no one any good.

[Mousey]

I'm using 4D/Openpli, anything else you need?

[Larry-G]

Sadly I am not overly familiar with the inner workings of that image.

[abu baniaz]

Even at saying OPenPLi/4d, you have not said which one.
They have put Vhannibals auto settings on some of their images. So you could have had three possibilities of issue. It isn't an image update.

We know very little about your setup, so our attempts to help are guess work. As above, run ABM, that will sort out your channel settings.

[manicscrewdriver]

I would just reflash the box and start from fresh. Its the best way and only way in my opinion to repair a corrupted image

When i saw the thread title i thought you were talking about me

Nano

[marty]

Better to use VIX too

[Mousey]

I left the box to it's own devices while l had some lunch and now cannot get a single channel and have no "tuner status", l'm thinking l should do a full reinstall.

[abu baniaz]

Full install would be best.