No western satellites on TM nano oe tuner

[satnano]

I have the latest vhannibals motor satellites and channels list installed but when I go the tuner configuration (advanced mode) I don't seem to access any western satellites from 1 west to 45 west, all I see 3.1 east to 75 east satellites. How I can get access to the western satellites in order to be able to manually tune them. Any help is greatly appreaciated.

[abu baniaz]

"Latest" is ambiguius.
Which image are you using. Please specify thename and build number.
Vhannibals latest motorised one is dated 20/04/2014. Is this the one you are using?

You may wish to use a satellites.xml from

http://satellites-xml.org/

and replace the one in Vhannibals one.

[satnano]

Many thanks Abu Baniaz, yes it is vhannibal 20th April one and I have replaced the satellites.xml via fizella, as you suggested, but I still can't see the western satellites as a choice in the tuner configuration menu. I can see 1.6 East till 75 East satellites and that is all.

[abu baniaz]

Try it this way, save the xml file in the same folder as your Vhannibal bouquet and then transfer the channel lists using Dreamset/Dreamboxedit.

I've just tried Vhannibal's 20/4 and all the satellites are there. You are going past "all satellites" until you reach the western ones?

[satnano]

I have already transferred vhannibal motorised channel list via dreamboxedit. In tuner config, I am going through all the eastern satlleites then "all satellites 1" through to "all satellites 4" then the eastern satellites start again, there is no sign of western satellites.

[satnano]

A proper restart by switching the receiver off from back button and then on, brought the western satellites. Sorry for the bother from a newbie.

[Rob van der Does]

A proper restart by switching the receiver off from back button and then on,...

Pulling the plug is not a proper restart; it can even kill your box. Always bring the box down (to deep sleep) before doing that.
Anyway: an Enigma2 restart after changing the satellites.xml would have done the trick.

[satnano]

Pulling the plug is not a proper restart; it can even kill your box. Always bring the box down (to deep sleep) before doing that.
Anyway: an Enigma2 restart after changing the satellites.xml would have done the trick.

Thanks Rob van der, Believe me I did restart Enigma2 via Dreamboxedit after installing Vhannibal 20th April file but this didn't load western satellites for some reason!!

[ronand]

Just use the remote