Set both tuners identically as diseq a/b. Leave the satellite as automatic. It will scan conencted sats automatically detect the sats and populat the entried for you. Label the cables afterwards.
Set both tuners identically as diseq a/b. Leave the satellite as automatic. It will scan conencted sats automatically detect the sats and populat the entried for you. Label the cables afterwards.
You don't have the lottery numbers do you?
Sent from my GT-I9505 using Tapatalk
So just set them up as in your photo? Then scan
Sent from my GT-I9505 using Tapatalk
My previous photo is based on info that you knew which cable was which. You later said that you were not sure which cable was which. At this point I said to set to automatic so taht it automatically detects what you have. Following picture depicts both set to auto as well of one with scanning process. When it finds the satellites, the names will be populated.
Last edited by abu baniaz; 23-11-13 at 20:40.
Stu5 (23-11-13)
Brilliant, thank you very much.
Sent from my GT-I9505 using Tapatalk
That worked a treat, tuners are now properly set up, on to getting the channels up now. Thank you to all that contributed. Feel like I learnt a few things in the last 24 hours.
Sent from my GT-I9505 using Tapatalk
Okay, so some hotbird channels are showing up now but when I go to watch a channel I am just getting a blank screen, I am getting now and next information but no picture. Any ideas?
Not sure if this next bit of information is of any use but.....
When I go into Menu/Setup/Service searching/Sat finder
Tuner A
Satellite 28.2e is showing 81% SNR / 91% AGC
Tuner B
Satellite 28.2e is 85% SNR / 91% AGC
But for Satellite 13.0e SNR and AGC are both 0%
Thanks
Hi hammy, how do backup?
Sent from my GT-I9505 using Tapatalk
blue button>vix>backup manager>green button
this will create a backup of all your existing settings and can be restored later by accessing the same menu.
handy if your tuner set up gets mixed up etc
ham
vu+ solo2 1tb hdd
vu+ duo2, 2x dvb c/c/t2 1tb hdd
lg 55" 4ktv, lg 42" led
13.0e, 19.2e, 28.2e
100 meg vm broadband
Great tip, thank you
Sent from my GT-I9505 using Tapatalk
I know that it is a steep learning curve. Do you really need a backup to restore this tuner setup? As with all tuner setups, the vital thing is that the config must match hardware.
@Stu5,please confirm that
A. You know which cable is which and that you have labelled them.
B. For the 28.2 tuner, you have set this to simple, single 28.2
C. For the tuner with coax coming from the diseqc switch, you have it set as per post 27.
For the diseqc tuner port b is 13.0e Eutelsat hot bird 13b/13c/13d
Sent from my GT-I9505 using Tapatalk
Yes to all, though for port b on the diseqc cable it is 13.0e eutelsat hot bird 13b/13c/13d
Sent from my GT-I9505 using Tapatalk