Hi I'm having probs with epg freezing when reading titles, I've sort of just asked a question in the solo2 pages but as I understand it that box may or not have problems so I've moved to the nano thread which is defiantly having problems.
Thanks.
Do the following:
Telent init 4 commaned
FTP to EPG storage location and delete Crossepg folder and epg.dat
Telnet init 3 command.
Re-download EPG.
D I S C L A I M E R
My right to post information is protected under the rights for freedom act. In all instances, information discussed here on my posts are either hypothetical in nature, out of general curiosity, common knowledge, public knowledge, or role-play. Any use of the collective descriptions and shared knowledge from any of my posts are at the sole discretion of the reader. I am not responsible for what you do with it!
Please help keep OpenViX online, donate HERE.
Rules can be found HERE
Support our sponsor World-Of-Satellite HERE
GIGABLUE UHD QUAD 4K, VU+ DUO 4K SE, ZGEMMA H7S, VU+ UNO 4K SE
Triax 1.1m Powered by TM2600, Fixed 28.2 Zone 2 dish with GT-SAT Unicable
Doesnt work, crashes on reading titles 195kb again same as last night and the hard drive sounds like it can't read... do i not need to download an older version first?
If have exactly the same problem on my Duo. Reads to 195kb and then doesnt go any further. I only have partial EPG too.
Where are you guys saving EPG data to? USB, HDD, Network?
Just helped someone install Vix 783 afresh having been on 4D. Cross epg 0.7 downlaoded fine. He used a fat32 usb flash drive.
Sicilian (13-11-13)
Mine is to a usb stick. The solution to this is to remove the crossepg plug in, reboot and re-install. Mine worked after that.
Never had a issue with the Nano or any other TM model with the new CrossEPG but after seeing this thread i flashed build 785 to test results below.
From start to finish it took just under 1 minute for sky uk and freesat.
Even after adding sky Ireland to ABM and doing a scan after it's done its work as well and it still only took just over 1 minute ( 1 minute 3 seconds to be exact ).
My posts contain my own personal thoughts and opinions, they do not represent those of any organisation or group but my own.
If you don't like what I post, Don't read it.
SIMPLES.
My epg saves to internal hard drive, I uninstalled the epg plug in, deleted files and installed the 6.8 version and it works fine, if you are saying I need to do a clean install with no restore to get 7 to work then that Is too much messing for me to do with 2 different boxes and a motorised sat setup on a work night.
Still works perfectly for me using settings backups and clean installs, I have tested on all my Vu+ and TM-OE receivers with no noticeable issues, all of my EPG's are saved to either a internal HDD or a mounted USB stick, as for too much messing when you get round to it you should be able to do a full fresh install in less than 20 minutes i can do it in less than 10 on my boxes.Originally Posted by DaMacFunkin
My posts contain my own personal thoughts and opinions, they do not represent those of any organisation or group but my own.
If you don't like what I post, Don't read it.
SIMPLES.
Posting Permissions
Reply With Quote
