VU+duo2 transcoding capabilities

[Trial]

Hi.
TS is a container and can contain mpeg2 (SD) or h264 (mainly HD). Transcoding should work and reduce Bitrate. I do not know BH but perhaps try latest 2.08 and ASK in their board.

Ciao

Gesendet von meinem Nexus 4 mit Tapatalk

[AJT]

Hi,
I have blackhole 2.0.7.3. installed on my new VU+DUO2. and i have the follwing problem with transcoding:
-I have opened both ports (8001 and 8002transcoding) and i have the streams working on both ports. I am trying to stream and transcode an FullHD chanell. I left the reciever working and from external location i managed to open both of the streams whitout problems with VLC and with WMP. Unfortunatelly i see no transcoding working. Both streams are with parameters: h.264, 1920x1080, 25 fps, Bitrate 4000-15000 kbit/s. I have tried to change the parameters on the reciever (bitrate, fps) but without sucess. It looks like both streams are absolutelly indentical.
Why transcoding feature is not working? Do i need to install some plugin? Is it possible the reciever to have a defect and can not make transcoding? Why the natural stream is in h.264 format? I though all natural sterams in general from any linux sat. reciever is in ts format?

Please help, as i start to think, that i have to replace the reciever!
Thank You!

This is for vix image problems..try vu+/blackhole for image elated problems orrr flash VIX.

[judge]

This is for vix image problems..try vu+/blackhole for image elated problems orrr flash VIX.

No, we support all images as much as we can, it's just that most of us here use ViX.

[danivtec]

Vu+ drivers are still not working fully with the transcoding function. It's not working at all with the latest drivers by the look of it and was hit and miss before that.

[Tkr001]

Yep, its crappy drivers. VU+ have really cocked this up and need to get their act together. I spent good coin on a Solo2 and a Duo2 and neither will transcode to my mobile devices any more.

[alomgir371]

Hi Guys,

I was thinking of upgrading to the Duo2 but was wondering if you knew whether this driver issue for transcoding has been resolved?

Thanks

[Trial]

Hi,
for Duo2 transcoding is working. I think only Solo2 has problems at the moment.

ciao

[Tkr001]

Not on my duo2 it isn't

[judge]

It's working on current test builds, also working on the Solo2.

[Tkr001]

It's working on current test builds, also working on the Solo2.

Great, I am holding my breath for VIX 4 to be released

[avinitski]

Are the latest drivers released inbuilt in the new OpenVix Zeus image?

[Rob van der Does]

Yes .

[avinitski]

I believe that in order to use transcoding the default port 80 must be used and no authentication can be set, if this is a driver issue from VU+ I feel almost cheated into spending so much money on a box and all that bloody advertising they do that this is THE streaming device.

I have to use build 753 of Vix as this is the only build that I feel streaming works to a satisfactory level.

If it is drivers then are there different drivers from build 753 to Zeus? Can the old drivers not be imported into Zeus?

[Rob van der Does]

Transcoding works fine on Zeus.

[Johev]

Transcoding works fine on Zeus.

Dear Rob van der Does, does zeus also support double transcoding for the DUO2?

Many thanks for your reply.