how can i config tuner of solo2 with black hole 2.0.5
i config. as i config in solo but no chanbel work
please need help
how can i config tuner of solo2 with black hole 2.0.5
i config. as i config in solo but no chanbel work
please need help
We need a little more information about your setup. Such as what kind of motor etc your trying to setup.
Sent from my GT-I9300 using Tapatalk 2
My posts contain my own personal thoughts and opinions, they do not represent those of any organisation or group but my own.
If you don't like what I post, Don't read it.
SIMPLES.
i have 13 satellite motorized set in tuner 1
and chosed :-
config mode =advanced
.lnb1...
tone mode=band
diseqc mode= 1.1
committed diseqc= aa.
uncommitted = input1
found this if it helps.
http://www.world-of-satellite.com/sh...ate-Positioner
Why are you using diseqc commands? Do you have a switch connected too?
no i have not switch connected only i have one cable from lnb sat connected to toner 1 on solo2
when i config as single mode the sat work but when i make the same seting to anther sat confg. the sat i seting before disappear ?
are you trying to loop the signal through between the tuners ? if so you have to connect the coax / feed to Tuner B and then loop it through to Tuner A for it to work.
My posts contain my own personal thoughts and opinions, they do not represent those of any organisation or group but my own.
If you don't like what I post, Don't read it.
SIMPLES.
Are you able to use USALS motor controls?
sorry i just need picture of tuner config with one cable connect to toner1 and config about 13 stalitte without use tuner2 just one cable one tuner 14 satlitte
as the config. tuner of solo
see this post. don't worry about the number of satellites.
http://www.world-of-satellite.com/sh...l=1#post223562
I asked a question in order to help you. you have yet to answer.
sorry to late answer u
about motor i use external motor so i dont need set motor in solo2
just config and move to satlite with external motor
What do you mean by "external motor"?
The configs in that post should work for most people provided that the motor/dish is aligned correctly. Here they are for you.
your tuner configuration for the motorised tuner should be:
Config mode = simple
Mode = positioner
Longitude = enter your values (west, if values from dish pointer are negative)
Latitude = enter your values (south, if values from dish pointer are negative)
Leave the other options at the default values.
You can get your co-ordinates from dishpointer.com. If your dish aligned correctly, it will calculate the positon of every satellite. You can then scan individual satellites or transfer a premade chanenl list or a combination of both.
Last edited by abu baniaz; 09-09-13 at 18:38.
good every thing work now good all satlitte