IMAG0035 (Small).jpgIMAG0037_BURST002 (Small).jpg
any solution.?
IMAG0035 (Small).jpgIMAG0037_BURST002 (Small).jpg
any solution.?
What image are you using?
What is the L4L-setup you made?
I think you should read a bit in this thread
Help asked via PM will be ignored.
The forum is there for help and all will benefit from your questions.
NO CARD SHARING TALK WILL BE TOLERATED, LAN OR WAN, IN OPEN FORUM OR PM !
English is not my native tongue.
I apologise for all my grammar, spelling and idiom errors.
Has it always been like that?
Looks like stuck pixels to me, happens on low quality LCD screens, not sure who you brought from but I would check if stuck pixels is a warrantable item.
I'm guessing it would be due to the LCD screen being one of the main differences between SOLO2 and DUO2 and a main LCD screen being a main selling point.
I used BlackHole 2.0.5 image and openvix-3.0.720 image and still was same line in LCD.
I didint touch any settings in LCD4Linux.
Hardware fault (broken LCD). Return the receiver to seller and get a new unit, if possible.
seems like a faulty lcd but you can try if you want;
stick50jr (24-08-13)
I had that problem on a brand new laptop, it was ok for a few hours then a stright line across the screen appeared . I took it back to the store and they admitted it was a common fault with the ribbon cable no securing properly. Needless to say i got a refund.