Done.
I can't see anything wrong in your setup.
Done.
I can't see anything wrong in your setup.
Help asked via PM will be ignored.
The forum is there for help and all will benefit from your questions.
NO CARD SHARING TALK WILL BE TOLERATED, LAN OR WAN, IN OPEN FORUM OR PM !
English is not my native tongue.
I apologise for all my grammar, spelling and idiom errors.
Going by the sreenshot and your IP address your longitude looks way wrong. Also if using a diseqc motor why are you using advanced?
D I S C L A I M E R
My right to post information is protected under the rights for freedom act. In all instances, information discussed here on my posts are either hypothetical in nature, out of general curiosity, common knowledge, public knowledge, or role-play. Any use of the collective descriptions and shared knowledge from any of my posts are at the sole discretion of the reader. I am not responsible for what you do with it!
Please help keep OpenViX online, donate HERE.
Rules can be found HERE
Support our sponsor World-Of-Satellite HERE
GIGABLUE UHD QUAD 4K, VU+ DUO 4K SE, ZGEMMA H7S, VU+ UNO 4K SE
Triax 1.1m Powered by TM2600, Fixed 28.2 Zone 2 dish with GT-SAT Unicable
It worked fine for OP when the motor was attached to tuner A.
And tbh I would never use 'simple' as then you have no control at all.
But both 'simple' and 'advanced' should be fine anyway.
Help asked via PM will be ignored.
The forum is there for help and all will benefit from your questions.
NO CARD SHARING TALK WILL BE TOLERATED, LAN OR WAN, IN OPEN FORUM OR PM !
English is not my native tongue.
I apologise for all my grammar, spelling and idiom errors.
There is an easy check for if you have a faulty tuner module, set tuner A/B into "Not Connected" and then set C/D to be simple and check if you can watch (move the active tuner to simple depending on setup you want to check)
If you can watch then it's not the tuner but most likely they way you have it set up. At worse it could be Vix but so far I've not had any issues.
I will today try and record 3 or 4 items on differing transponders, and report back.
My set up is 2X dual Sat Tuners A/B and C/D with
A/B on a fixed dish pointing at 28.2
C = on a motorised dish currently pointing at 19.2
D = Not Connected (I've a single LNB on the motorised dish)
OP has in fact done the same.
Help asked via PM will be ignored.
The forum is there for help and all will benefit from your questions.
NO CARD SHARING TALK WILL BE TOLERATED, LAN OR WAN, IN OPEN FORUM OR PM !
English is not my native tongue.
I apologise for all my grammar, spelling and idiom errors.