Hi lads my box just stopped working. I turned it off, waited about 5 minutes and rebooted. Now its stuck on starting on the front panel with a red light next to it. See pic. I have tried different versions of images and nothing.
photo.JPG
Hi lads my box just stopped working. I turned it off, waited about 5 minutes and rebooted. Now its stuck on starting on the front panel with a red light next to it. See pic. I have tried different versions of images and nothing.
photo.JPG
I know it can be very frustrating when things like this happens, i read someones post recently with the sme problem they turned the box off unplugged from wall and left for 30 minutes. They then plugged in restarted box and it started working, sorry can't give much more but give it a try.
Vix image (usually latest) - VU Solo 4K- WD 1TB INTERNAL HDD - DVB-T Freeview, trialling IPTV options
If my response has helped you, don't forget to hit the thanks button below. I appreciate you appreciate me
mine does this when ever i try the BH image, it simply refuses to load any BH image at all, the only way we would know whats causing it would be if you could create a serial boot log, failing that try flashing a different image then ViX again and see if that makes a difference.
My posts contain my own personal thoughts and opinions, they do not represent those of any organisation or group but my own.
If you don't like what I post, Don't read it.
SIMPLES.
that image is????
that image had before????
Image now is 3.0.204....Image before was 3.0.696
Hi Mate
Have you disconnected any hdd or usb sticks connected to the reciver then rebooted also try and flash manufactures original image
I was using that image mate when it crashed so I went back to an older image just to try and get it up and running again. The hdd is internal satmanbasil
Left it off for over 30 mins started up...still the same thing. Tried loading newest VIX image no good. Downloading original image now. Might disconnect the internal drive as well just to make sure
Ok ruled out the hdd issue. Drive was disconnected and still no boot up
Ok I loaded up an original image to the Uno and the Starting changed to Vu Uno. Then the box booted to the Vu+ sign and did no more.
Hi mate
When you flash does the box see the usb stick and proceed to install the image or do u when powering up just get what your picture shows.
reason i asked it could be the red light of death but normally when this happens you get just the red light so for others to help we need to know if the receiver is responding to the usb flash and remote as these dont work when the red light of death occurs
Hi mate
So the usb ports must be working for the flash to run you are reporting whats happening on the stb display but whats happening on your tv screen does it show the setup, remember when you flash the box is in virgin state and you have to complete the setup before it will show any channel info on your display
hi again
you say you loaded an original image did you make sure the boot loader was up to date before you did that?
Hi mate so many questions lol....I loaded the first ever original image and it booted up channel scan and everything. Then when I loaded up the vix image again nothing. Back to stage 1. Think I will load up original again and stick with till tomorrow. Cant understand it though. It was running fine