any further news guys?
any further news guys?
Just upgraded to 680 and the black screen as now been fixed on my tm-single.
Rebooted a number of times with out any problems.
Ignore above post just had a black screen after a reboot.
No issues like this on any of my boxes.
Are ye restoring plugins or settings from older back-ups?
If so, which builds?
If not, what start-up channels does it happen on, FTA or all?
What cams have ye enabled on strat-up?
How are you generating your channel lists so & for what sats?
Do you have a start-up channel set?
I've tried the 20/02/2013 drivers, issue still there so rules out the 03 June ones being at fault.
For me, Channel list is Vhannibal list supllemented by a run of Lraizer's plugin. Satrtup service set to BBC One (never needed one before) and picture is shown after a momentary spell of blackness. In effect same as not having startup channel set.
no idea so mate, all I can say is I've never had the issue, updated 5 different boxes this week, 4 different models, all using ViX, Cccam 2.3.0 & no issues on startup of FTA or decoded channels.
Is all your cabling ok?
Issues reported only on TM models so far. It is not a big one as a channel change resolves it, an issue nonetheless. Rebooting receivers is not a frequent activity.
Did those logs I emailed show anything of use? Would be good if others experiencing the phenomena could send their logs in too.
While I'm not keen on the way TM are sending/testing new drivers for ViX, I can say that both my TM2T & TMTwin, using build 680 don't suffer these issues.
Fresh flash, AMB for Sky UK & IRE, Cccam 2.3.0 & no noticable delays on start-up viewing any channel.
Saying that, using the drivers included in build 680, the 28% loading screen is once again a pain in the ass on a fresh reboot, can take up to 5 minutes to get past it, once done watching live TV is fine. Could be a HDD check but if so, shouldn't happen every time...