Standby problem

[01342]

So I never used cache flush, mainly because I couldn't install it. I did put it to standby last night with a power timer to deep sleep then wake to standby before doing an EPG update and bouquet update. Today when I woke the box was back to a red light but did turn on ok and turned on with sound
Great I thought.
However, just about 2 minutes later a black screen appeared with the revolving logo. When the screen came back the sound had gone so it was another restart.
There were 2 new debug logs there this morning so I've attached both.
Seems I'm not out of the woods yet. I'm thinking this box may be faulty as my other Solo and Solo2 don't behave like this.

Cheers,

Keith.

[mickyblueys]

just for piece of mind it might pay you to do a fresh flash. At least then you know where you are at. I mean apart from your standby issue, there is obviously other problems underlying, if the cache flush plugin failed to even install correctly.

Then you are starting from a "blank canvas"

Just a suggestion.

Sent from my GT-I9100 using Tapatalk 2

[01342]

just for piece of mind it might pay you to do a fresh flash. At least then you know where you are at. I mean apart from your standby issue, there is obviously other problems underlying, if the cache flush plugin failed to even install correctly.

Then you are starting from a "blank canvas"

Just a suggestion.

Sent from my GT-I9100 using Tapatalk 2

Thanks for all your help and suggestions. I have already tried a re flash. Do you think anyone from the sponsor will be along to offer any advice any time soon?

Cheers,

Keith.

[01342]

Do you think anyone from the sponsor will be along to offer any advice any time soon?

No? Seems not.

So, woke up today to a green light on and no sound.Again. Overnight 2 logs were produced, both attached. Time to contact the sponsor/seller I suppose.