tuner config

[scoutee]

Hi setting up tuners not sure if to set up both the same or to put B on loopthrough. thanks for any info

[mickyblueys]

A little more info would help!!

Sent from my GT-I9100 using Tapatalk 2

[scoutee]

more info vu+solo2 fixed dish sly tuner a tuned for sly channels not sure if b should be on a loopthrough

[mickyblueys]

I have mine both on simple, single.......I don't use loopthrough.

Sent from my GT-I9100 using Tapatalk 2

[scoutee]

many thanks

[Trial]

Hi,
only if two separate cables are connected to the box. If you only have one cable you have to put it into tuner B and A loop through to B.

ciao

[mickyblueys]

Hi,
only if two separate cables are connected to the box. If you only have one cable you have to put it into tuner B and A loop through to B.

ciao

Didn't know that as I have two cables

Sent from my GT-I9100 using Tapatalk 2

[redribo]

I have one cable in tuner a and the config of the tuner b is loopthrought to a.
is this coorect?
why r u saying to put cable to tuner b?

thank you

[Trial]

hi,
what did I write in my previous post?

ciao

Gesendet von meinem GT-P1000 mit Tapatalk 2

[warajoker]

Hi setting up tuners not sure if to set up both the same or to put B on loopthrough. thanks for any info

do this for both of the tuners.


Configuration mode - simple
Mode - single
satellite - 28.2eutelsat 28A & Astra 1N/2A/2B/2F
Send Diseqc - no

[redribo]

can you explain to us why we have to put cable only in tuner b and loopthrought to a?
and why not cable to tuner a and loopthrought to b?

thank you

[Rob van der Does]

can you explain to us why we have to put cable only in tuner b and loopthrought to a?
and why not cable to tuner a and loopthrought to b?

Because the hardware only support the internal loopthrough in that direction. But for a user this makes no difference at all.

[redribo]

i have put the cable on tuner A and i have configure tuner B to be loopthrought to A and works all ok with the channels on same sat and same polarization.

how can you explain this ,if the software doesnt support this?

thank you for your answer

[Rob van der Does]

i have put the cable on tuner A and i have configure tuner B to be loopthrought to A and works all ok with the channels on same sat and same polarization.

Then you have done a wonderful job and should apply for a well paid job at VU's......

how can you explain this

I can't.
I can only say that VU+ themselves say this to be not possible. And in my solo2 it indeed isn't.

[redribo]

very strange,in my solo2 working at pip mode,
i think that there is choice to loopthrought tuner b to tuner a,if was impossible then there isnt such a choice.

i turn on pip and i can see channels on same sat and same polarization and different provider,transpoder.