Help asked via PM will be ignored.
The forum is there for help and all will benefit from your questions.
NO CARD SHARING TALK WILL BE TOLERATED, LAN OR WAN, IN OPEN FORUM OR PM !
English is not my native tongue.
I apologise for all my grammar, spelling and idiom errors.
Probably a 3d led
Couldn't agree more. Fault is with the plasma, not the STB. The plasma is kicking out random waste interference which is messing with the valid signal from the remote. If you had your STB in a cabinet, and the wood was blocking the IR signal, would you blame the STB or the cabinet, or would you just implement a solution?
LCDs sometimes interfere when the picture is very dark on the screen, even fluorescent light bulbs can cause similar problems. Try tape on the outside first, this should work. If it doesn't, then alien2108's solution prob will work if you are willing to get your hands dirty.
MGT (18-01-13)
Help asked via PM will be ignored.
The forum is there for help and all will benefit from your questions.
NO CARD SHARING TALK WILL BE TOLERATED, LAN OR WAN, IN OPEN FORUM OR PM !
English is not my native tongue.
I apologise for all my grammar, spelling and idiom errors.
Changing the remote code did nothing so I opened it op and put a couple of strips of insulation tape in front of the remote sensor. Only had yellow tape but seeing as its inside you really don't notice it. Seems to have done the trick.
Anybody contemplating doing it, don't be afraid. It really is a piece of cake.
The higher I put engery saver on the better it works. I've put it on medium and Its better now