VU+ Solo 2 + Motorised Dish Setup

[Stanman]

Rules apply to LAN and WAN

[Easty]

Appologies

[ja5]

Well its good you not given up so easy its all about learning and if u have problems or want to change things later you can do it lol

Have you tried dishpointer and enter you postcode and 0.8 and it show you dish setup and see what you set your dish too.

Thanks for the replys guys.

My setup is quad technomate lnb , technomate motor , 80cm technomate dish.

1st feed from lnb to motor - motor to reciever
second feed from lnb straight to reciever

Ive got the motor setup as per the guidlines on my latitude / longititude but somewhere somthing has got to be out as ive gone through all of the satellies in my list and get no signal on all of them but the meter is defo giving me a good reading on 1 somwhere

I think im going to take the dish / motor down and have a play with a ground mount at my workplace and work out how to use the meters and get it setup properly ive made up some spare satellite cables so will have a play in the week.

[Easty]

Well its good you not given up so easy its all about learning and if u have problems or want to change things later you can do it lol

Have you tried dishpointer and enter you postcode and 0.8 and it show you dish setup and see what you set your dish too.

It works perfectly fine on the sly uk dish so I know the config on the box is ok. Just need to get the dish down and make sure its all as per dish pointer states and go from there.

But ive learn quite a bit already in the last few days..