I have put the VIX image on my TM-2T now it will not respond to the remote or any of the front buttons.I have tried a new image but it will not go in,is there anything else I could do possibly through the 232 port? regards waltwal
Have to pressed STB button top right of the remote?
D I S C L A I M E R
My right to post information is protected under the rights for freedom act. In all instances, information discussed here on my posts are either hypothetical in nature, out of general curiosity, common knowledge, public knowledge, or role-play. Any use of the collective descriptions and shared knowledge from any of my posts are at the sole discretion of the reader. I am not responsible for what you do with it!
Please help keep OpenViX online, donate HERE.
Rules can be found HERE
Support our sponsor World-Of-Satellite HERE
GIGABLUE UHD QUAD 4K, VU+ DUO 4K SE, ZGEMMA H7S, VU+ UNO 4K SE
Triax 1.1m Powered by TM2600, Fixed 28.2 Zone 2 dish with GT-SAT Unicable
Yes I have done that with no effect on the stb it will not respond to any of the front buttons either.many thanks for propt reply, regards waltwal
Do the following: -
Re-flash the bootloader http://www.world-of-satellite.com/en...loaders/TM-2T/
Once complete, power off. Then power on repeatedly pressing exit on front panel for 30 seconds.
Power off.
Flashed latest ViX image 521 http://www.world-of-satellite.com/en...php?dir=TM-2T/
D I S C L A I M E R
My right to post information is protected under the rights for freedom act. In all instances, information discussed here on my posts are either hypothetical in nature, out of general curiosity, common knowledge, public knowledge, or role-play. Any use of the collective descriptions and shared knowledge from any of my posts are at the sole discretion of the reader. I am not responsible for what you do with it!
Please help keep OpenViX online, donate HERE.
Rules can be found HERE
Support our sponsor World-Of-Satellite HERE
GIGABLUE UHD QUAD 4K, VU+ DUO 4K SE, ZGEMMA H7S, VU+ UNO 4K SE
Triax 1.1m Powered by TM2600, Fixed 28.2 Zone 2 dish with GT-SAT Unicable
Thanks for the assistance I have now got the box working OK but could not get the vix in it but did manage with a 4D image this I cannot understand I will have another try on another day
Thanks again regards waltwal
You need to put the folder called Update on the USB and power down and off from the rocker switch at the back and than remove any other USB devices you have connected, stick the image uSB in and power on - flashed mine yesterday and it updated fine.
Support The Sponsor - Buy from the best HERE
Please abide by the rules - have a read HERE
VIX manual & guides >>HERE
Download images from >> HERE
New Box Setup Guide >>HERE
D I S C L A I M E R
My right to post information is protected under the rights for freedom act. In all instances, information discussed here on my posts are either hypothetical in nature, out of general curiosity, common knowledge, public knowledge, or role-play. Any use of the collective descriptions and shared knowledge from any of my posts are at the sole discretion of the reader. I am not responsible for what you do with it!
PM HELP WILL BE IGNORED PLEASE POST HERE IN FORUM AS IT BENEFITS EVERYONE
Follow us on Twitter
NO CARD SHARING TALK WILL BE TOLERATED, LAN OR WAN! IN OPEN FORUM OR PM
IF THE POSTS HELP PLEASE CLICK THANKS OR ADD TO REP ?
Did you delete the existing "update" folder on the flash drive?
Posting Permissions
Reply With Quote
