i did a factory reset through the box controls but now the box will not boot up, can anyone help please?
i did a factory reset through the box controls but now the box will not boot up, can anyone help please?
Sound like you need to re-flash it.
Hold down the power button when powering up, this will give the last 3 digits of the receivers IP address of your network. Access the web interface and flash with the latest UR image.
D I S C L A I M E R
My right to post information is protected under the rights for freedom act. In all instances, information discussed here on my posts are either hypothetical in nature, out of general curiosity, common knowledge, public knowledge, or role-play. Any use of the collective descriptions and shared knowledge from any of my posts are at the sole discretion of the reader. I am not responsible for what you do with it!
Please help keep OpenViX online, donate HERE.
Rules can be found HERE
Support our sponsor World-Of-Satellite HERE
GIGABLUE UHD QUAD 4K, VU+ DUO 4K SE, ZGEMMA H7S, VU+ UNO 4K SE
Triax 1.1m Powered by TM2600, Fixed 28.2 Zone 2 dish with GT-SAT Unicable
i tried that with no luck, i put on the image that i was running and it wont boot up, any other ideas
Your best bet it to flash it again with a null modem cable here is a tutorial by digidude and Technomate_ControlCenter_7_1
Tutorial on how to update your linux technomate receiver via serial lead
All PM,s asking about c/s on cable will be ignored and reported to forum staff!
Sicilian (18-09-10)
cheers, i will give that a go
worked a treat, thanks
Glad you are sorted
All PM,s asking about c/s on cable will be ignored and reported to forum staff!