Help installing CCcam

[Sicilian]

Irdeto and Mediaguard 3 are encryptions. I doubt that its Irdeto as you haven't added any extra config lines to CCcam.cfg.

[jas]

Hi
I want to reflash my VU+ solo how can i save CCcam (line) and put it back.

Thanks

[silverfox0786]

ftp and get t out of folder /etc

[jas]

Hi
If i flash with usb stick, install updates, install ccam from saved places, add bouquet will this be back up or i am missing anything.

Thanks

[Stanman]

Yes, but why done you just back up your settings and than reinstall them - this will not save your CFG file though that you will need to do as silver said.

[jas]

how can i backup settings, can i backup to attached hard drive please let me know how can i do it. Thanks

[Stanman]

Yes you can, if you go into vix and software - its in there back up. not at the VU if yu get stuck will post eact path later on.

[jas]

Thanks
Just tried box keep crashings, tried setup-vix menu-image manager then green for new backup. Box crashed however i have got an old backup which was done when it was working. When i try to restore old backup box crash again i dont know what is gone wrong.

Hopefully full flash will fix crashig prob.

Thanks

[Stanman]

Thats the wrong one your trying to back up the image there and not settings.
Blue button press and than software management and its there back up settings NOT image

[jas]

Stanman, Thanks I have tried as you said and crashed with green screen.
Should i flash it, just thinking if i will be able to put everything back on. Help please if i am wright.

Flash with VIX1.1 via usb-install Ccam and Bouquet - put old cline setting in etc folder. Am i missing anything such as do i have to install EPG or anything else.

Thanks

[Stanman]

The only important one is your CFG file everything else you can download and reinstall.
You will need to download via plugin CCCAM and whilst at it you migth as well download the bouquets and picons, you might need to change the locations to your preferred one.

[jas]

i could not flash vu solo through usb with vix1.1 i think because it has already vix1.1

When i tried to reset to factory settings it worked then i updated through software manager, after done updates asked me to press ok to restart and i did.

When restarting it keep saying vu+ starting and not moving from that screen. Any help please......

I tried to switch of the power same again....

Thanks