Saving with usals

[vicjac]

When I make fine tuning to a satellite
the box does not saves the settings.
I tried with vix and vit image,with the same result.
Can anyone give me a clue?
P.S : I used the green button for save.
Thanks in advance.

[dream3R]

You need to use the advanced tuner settings.

Using that you can set usals on or off per satellite, I use it for tring.

You point the non usals satellite to a motor position memory entry.


You setup the motor memory from positioner setup.

[Rob van der Does]

When I make fine tuning to a satellite
the box does not saves the settings.
I tried with vix and vit image,with the same result.
Can anyone give me a clue?
P.S : I used the green button for save.
Thanks in advance.

"Saving" only works for non-USALS motor use. In fact it should be ommitted if USALS is not in use.
Instead finetuning when using USALS is far more easy: use the positioner, and turn the dish a bit to the east or to the west. If you see that SNR is improving, change your own position (in the tuner config settings) a bit to the other side. So if turning the dish to the East gave a better signal quality, move your position a bit to the West. Continue this procedure, up to the moment that no improvement can be achieved any more. Use little steps at a time: I suggest 0,1 - 0,2 degress each time.

Remember your "new" location when you are done, for a next set up!