Do you get the same if you use the remote in the webif (Web interface)?Originally Posted by B4RTJ
Dear Team,
Can someone advice how/where to change setting to show full screen when turning on?
At the moment, when I turn on zgemma h7s with remove (from stand-by?) it goes to a small screen with menu selection on the right, and every time I need to press "exit" to get normal viewing mode.
Tried various changes in menu and they even ended in numerous re-flashes as i couldn't re-trace my steps
Thank you in advance.
IMG_5313.jpeg
Find the ip of your box, menu/information/network/ip = xxx.xxx.xxx.xx
Type this IP into the address bar of your internet browser on your PC
The webif should appear - toward the LH top corner of that page there should be a virtual remote control. You may have to click on it to expand it to get more buttons.
Now put your box into standby via the physical remote control.
Then hit the on/off button in the webif virtual remote control.
Do you see the same problem?
Hello Guest, if you are reading this it means you have not registered yet. Please take a second, Click here to register, and in a few simple steps you will be able to enjoy our community and use our OpenViX support section.
Reply With Quote
