I cannot get Openwebif to run on my PC I typed http://tmtwin4k.local into the address bar and it fails every timewebif3.jpg
I cannot get Openwebif to run on my PC I typed http://tmtwin4k.local into the address bar and it fails every timewebif3.jpg
Maybe your router is not resolving the hostname. Just enter the IP address of receiver.
What problem are you having?
Have you flashed 6.0 007 yet?
redman1 (22-02-22)
Hello again . You have been amazing with your help.
I cannot thank you enough.
I have a big problem
As I mentioned, the box is working on the tv and I get a picture. BUT now it has OpenPLI installed.!!! How did that happen?
I don't know. They don't flash themselves. Did you have a USB stick in the receiver with the 4D/pli image?
Can you press select Menu > Information > About and take a screenshot/clear picture and uplaod it.
Do you want to flash Vix on it?
I had a USB in the box but it was the Vix 6.00.7 on the USB
Yes I want Vix to be the image on the box.
Is it possible to do it over PLI?
Here is Information pictureopenpli.jpg
Best you check the USB sticks for any images on them to be safe.
Ftp the vix image (still zipped) to the root of the hdd. i.e not in a folder. Then
Menu > Setup > Flash image > Downloaded image
The vix image should be there and you can flash it.
Hello
Please see picture
Thanksftp.jpg
Yes, that is correct location.
Ok
It is in the HDD - media/hdd directoryftp1.jpg
Pleas flash it as per rest of instructions in post 82. Please post a screenshot/clear picture if there is a problem
Menu > Setup > Flash image > Downloaded image
It should look similar to the attached screenshot. You will have to account for ~3 years of changes and the fact you are not using an official PLi image
Last edited by abu baniaz; 22-02-22 at 19:59.
Hello
Menu > setup > flash image is not on the box.open 1.jpg
I have this under software management
open 2.jpg
Hopefully, I might learn something here.
Sorry
Bear with me please