Quote Originally Posted by giorgoulla99 View Post
I have been told that the ET-10000 needs a v1.4 HDMI cable.
Do you think this may be the cause of the issue?
I have ordered one and hope to receive it on Monday.
It only needs to be a higher specification if you are attempting to send too high a data rate down the cable.
You can check this by setting the AV mode to, say. 480i or 760i to reduce the data rate to below that of the most inferior specified HDMI cable. (Menu -> setup -> Audio and Video -> settings -> mode)
If this cures the problem then it's a chance its the HDMI cable BUT during setup the wizard would have sent data down the cable at te rate you selected.

What are your settings for the video mode to and refresh rate? For UK broadcast TV 1080i and 50Hz is the maximum the ET10000 would receive.