Mutant HD51 - Motorised bug, has it been fixed?

[RustySpoons]

So a workaround for "bugged" Mutant drivers has fixed a Miraclebox too. How odd....

There are different issues, the one I reported about not locking after the motor moving etc was resolved with this "Commit"
From my testing it's an E2 issue and I came up with a work around that I posted elsewhere, I would have posted it here but no one replied to my PM.

This was then resolved with the latest commit.
Everyone seemed to point their finger at Mutant saying the motor issue is down to the driver but it's not, I can get any E2 box to do it.
However there is an issue with a driver to do with signal readings etc but that's another discussion.

[abu baniaz]

This was then resolved with the latest commit.
Everyone seemed to point their finger at Mutant saying the motor issue is down to the driver but it's not, I can get any E2 box to do it.

Wow, how have all other users with motors managed to use them?

[RustySpoons]

Wow, how have all other users with motors managed to use them?

This "Bug" was introduced at some point in 2017, it's only on OA-E Images, it affects ANY box that has that software on there.
The factors here are, have they all updated/installed an image with this bug?, do they move their motor much?, do they notice?
Reports on lots of different boxes, they said that the SF4008 is not affected, well it is.

I've tested it on numerous boxes, its an E2 issue not a Driver issue.

Doesn't happen on Non OA-E E2 sources, I have dreamboxes as well, doesn't happen with images from other sources on those.
Put a PLI based image on them and the bug is there.

[kipp3r]

This "Bug" was introduced at some point in 2017, it's only on OA-E Images, it affects ANY box that has that software on there.
The factors here are, have they all updated/installed an image with this bug?, do they move their motor much?, do they notice?
Reports on lots of different boxes, they said that the SF4008 is not affected, well it is.

I've tested it on numerous boxes, its an E2 issue not a Driver issue.

Doesn't happen on Non OA-E E2 sources, I have dreamboxes as well, doesn't happen with images from other sources on those.
Put a PLI based image on them and the bug is there.

Yes it certainly does effect the sf4008 , I have sf4008 & mutant hd51 and effects both but I did not realise it was a bug until I read this thread - now I know why it takes so long for channels to appear after switching to a different satellite, hopefully a remedy sorted out soon , thanks for the info lads.