Can't get dcc to connect my vu+solo se with my router
Last edited by 1067; 22-08-17 at 17:49.
Use something like filezilla, a much better ftp solution imo. DCC hasn't and isn't something that is being maintained anymore.
Sent from my iPhone using Tapatalk
Vu+ Ultimo 4K with 3TB HDD, Dual FBC (Sat) tuners, 1x Twin Hybrid DVB-C/T/T2 tuner
Vu+ Solo 4K with 1TB HDD, Dual FBC (Sat) tuners, 1x Hybrid DVB-C/T/T2 tuner
Vu+ Solo 2 with 1TB HDD 'White Edition', 2x DVB-S2 tuners
Mut@nt HD2400 with 1TB HDD, 4x DVB-S2 tuners
Fixed 28.2E Technomate 65cm Mesh Satellite Dish with Inverto Unicable II/JESS LNB and Inverto Unicable Splitter
Fixed 28.2E Sky Zone 1 45cm Satellite Dish with Octo LNB
(All receivers installed with the latest Dev build)
DCC as always worked fine for me, do a search to make sure the ip's are correct, also you can set to do direct crossover to the box , rather than modem.
use version 1.41
VU+ DUO2 quad tuner with HDD 1 TB + Latest Openvix and VU+ DUO2 FB tuner + Octagon SF8008 FB tuner
Triax 88 cm rotor single LNB 30 E- 40 W
1 Gibertini 1.00 m fixed - 3 quad LNB 19E-23.5E-28.2E
done a search for the ips dcc finds them ok when i start up dcc it shows connected to pc to box but not box to router green line from pc to box red line to router
in top left of dcc change connection type to direct crossover, then u can connect to box,
I'm having the same problem no trouble connecting to the blackhole lates 303 image but when I put the latest vix image on the dcc will not connect to my vu I'm using the 150 version of the dcc I'm using a vmedia router strange any help please
Posting Permissions
Reply With Quote