Hi,
I have just come off holiday and my ET9500 won't start up. When I power on I can hear the hard disc start and the blue light flashes about 5 times then nothing.
Can anyone help please .......
Hi,
I have just come off holiday and my ET9500 won't start up. When I power on I can hear the hard disc start and the blue light flashes about 5 times then nothing.
Can anyone help please .......
No help but mine doing exactly same this morning. Have you managed to find a solution?
Cristi's (16-05-18)
Cristi's (16-05-18),sabes143 (08-09-17),Stuckagain (10-05-18)
oh and all working again
Cristi's (16-05-18)
Cristi's (16-05-18)
fixed. swapped the two blown capacitors, plugged back in and all working fine.
Cristi's (16-05-18)
Gigablue Quad 4K & UE 4K
.........FBC Tuners:
------------------> GT-Sat unicable LNB to 1.5M dish(28.2E)
------------------> Gigablue unicable LNB to 80 cm dish(19.2E)
.......................
Vu+ Uno4KSE, Dreambox dm900
AX HD61, Edision Osmio 4K+, Zgemma H9Combo, Octagon SF8008 , gbtrio4k, h9se using unicable ports
Zgemma H9 C/S into Giga4K
Cristi's (16-05-18)
Cristi's (16-05-18)
So i think i have a similar problem with my xtrend 10000. It does not start. I hear a clicking sound when i turn the switch. But i can not tell if i have a blown capacitor
Look at it - the end will be bulging. Or you could post a close-up photo of the psu if not sure
Zgemma H7S running OpenVIX 6.2, Darkmotor, Triax TD110 dish, Inverto Black Ultra dual lnb
LG 50UM7450 4K TV, Pioneer VSX-534 Atmos AVR , Panasonic UB820 region free 4K Bluray & a PS4.
By the way don't stick your fingers in if you are not sure what you are doing - capacitors will hold charge even with the power off.
Zgemma H7S running OpenVIX 6.2, Darkmotor, Triax TD110 dish, Inverto Black Ultra dual lnb
LG 50UM7450 4K TV, Pioneer VSX-534 Atmos AVR , Panasonic UB820 region free 4K Bluray & a PS4.
Here you guys
Anything look dodgy to you?
Hum.. My ET9500 also died.. only Flashing the blue led, and able to draw somepower from the usb ports..
So after searching around i took a look on the PSU board..
but the caps seems to be "ok" as in.. there not bulging. i know, no warranty that there actually good..
so lets order some new caps :-)
So, Replaced my 3 yellow caps. and it fired up without any problems.
I did replace the 4700uF 10V with a 4700uF 16.. just to be sure :-)