The kernel upgrade on the et10k has rendered my rtl8192cu wifi pretty much useless, I'm stuck on 4.2.026, with, as you say, no more plugin access.
It also knocked my Sundtek usb tuner for six as well.
The kernel upgrade on the et10k has rendered my rtl8192cu wifi pretty much useless, I'm stuck on 4.2.026, with, as you say, no more plugin access.
It also knocked my Sundtek usb tuner for six as well.
Hello' I found this thread and it seems to be useful for my problem. I was watching a channel Gigablue Quad was working fine, then suddenly it shut down and started to boot loop.
Then I downloaded last Openvix image .25 from the website and after I flashed the image I cannot even start the regular setup or restore because the decoder is still rebooting continuously.
I wonder if it some hardware issue or I may try something else. In this condition I cannot telnet to the decoder at the moment.
If you have a PC then connect to your router and find out what address the receiver is using (its obviously at the point where it has not setup the normal internet IP)
Then telnet into the box with this IP
Init 4
Enigma2
Paste the log here
Gigablue Quad 4K & UE 4K
.........FBC Tuners:
------------------> GT-Sat unicable LNB to 1.5M dish(28.2E)
------------------> Gigablue unicable LNB to 80 cm dish(19.2E)
.......................> FBC & DVB-S2X into 90cm dish (27.5W) Opticum robust Unicable LNB
AX HD61, Edision Osmio 4K+, Zgemma H9Combo, Octagon SF8008 , gbtrio4k, h9se using unicable ports
Zgemma H9 C/S into Giga4K
MrKappa (18-08-17)
Hello' twol, many thanks for the reply.
I tried flashing only the bootloader and it has started normally, then I could restore the settings and it's working for now.
I will monitor the situation. I hope it's not a sign of bad memory condition or some hardware starting to suffer it's age.....
I will report in case of news.
Just for your info, I had to do this in the past, not sure I had to do it last time when I went to 5.0.017 or the time before.
But I also had to do it today when I went from 5.0.017 to 5.0.032 (USB Flash), was stuck in the same boot loop until I did.
GBQuad (NOT Plus version).
All working fine now.