Maybe its the hades image that is causing the issue? I will try a reflash today.
Every reboot causes my network to be lost. It only works if the box is fully powered down for around 15 minutes.
I will try Apollo
Cheers
Maybe its the hades image that is causing the issue? I will try a reflash today.
Every reboot causes my network to be lost. It only works if the box is fully powered down for around 15 minutes.
I will try Apollo
Cheers
No issues here with Hades 014.
You able to set your VM Hub to modem mode and test with another router?
D I S C L A I M E R
My right to post information is protected under the rights for freedom act. In all instances, information discussed here on my posts are either hypothetical in nature, out of general curiosity, common knowledge, public knowledge, or role-play. Any use of the collective descriptions and shared knowledge from any of my posts are at the sole discretion of the reader. I am not responsible for what you do with it!
Please help keep OpenViX online, donate HERE.
Rules can be found HERE
Support our sponsor World-Of-Satellite HERE
GIGABLUE UHD QUAD 4K, VU+ DUO 4K SE, ZGEMMA H7S, VU+ UNO 4K SE
Triax 1.1m Powered by TM2600, Fixed 28.2 Zone 2 dish with GT-SAT Unicable
Haven't had an ET8000 since Apollo was around, but always found that getting an IP address was pretty instantaneous and during that time I changed my main router (and supplier) with no issues.
In fact the only issues I have ever had was with the ET10000 with 2 LAN connections..... A bit of a pain.
Taking 5 mins for a router to provide an IP address sounds like a serious (router)issue.
Last edited by twol; 28-06-15 at 12:45.
Gigablue Quad 4K & UE 4K
.........FBC Tuners:
------------------> GT-Sat unicable LNB to 1.5M dish(28.2E)
------------------> Gigablue unicable LNB to 80 cm dish(19.2E)
.......................> FBC & DVB-S2X into 90cm dish (27.5W) Opticum robust Unicable LNB
AX HD61, Edision Osmio 4K+, Zgemma H9Combo, Octagon SF8008 , gbtrio4k, h9se using unicable ports
Zgemma H9 C/S into Giga4K
so over an hourunsure if its because its run off a broadband split has anything to with it.
further checking done moved from apollo 166 to open pli and that had no connection after box rebooted,put hades 14 back on still no network,ok i knew apollo connected so reflashedno network connection with powered off box and router and network restarts.
left box off for 1 hr and powered back up network wizard connected to lan?
sums my issue up pretty much. Im doubting it is my router as everything has worked perfectly until the introduction of the ET8000, pretty sure the box is faulty.
cactikid (28-06-15)
Ok, I went to my parents house earlier and set up over there. My network worked fine there. Came home and no network. Factory reset my router and all was good again, I thought I had beat the issue, but I have just attempted a reboot and the network is gone again. Hmmph, seems the problem is my superhub, I'm just not sure why
is yours the early version as they had issues as sicilian says,try adding a router to your hub and try your lan in that,kryptview cable boxes had the same issue at one time with the super hub early version.
i am not so lucky mine is off again
I have the latest superhub 2. Today, I have no network at all, and the power down trick has stopped working. I tried in modem mode, no change. I really am starting to think the box is the issue, and the fact it spring into life yesterday was just a freak coincidence
So can you take it somewhere else pther than your parents andtest again?
If it works at 2 places but not your home, then its likely an issue with your home lan.
Also mod the router to a range of say 100 addresses, set dhcp off in the ET8000 and a fixed IP of say 150 and see what happens. as most routers never reach any where near a xxx.yyy.zzz.100 you can probably get away without doing the 1st step, just fix the IP on the box.
I always run with fixed IP,s so that I always know which of my receivers I am talking to......
Last edited by twol; 30-06-15 at 12:04.
Gigablue Quad 4K & UE 4K
.........FBC Tuners:
------------------> GT-Sat unicable LNB to 1.5M dish(28.2E)
------------------> Gigablue unicable LNB to 80 cm dish(19.2E)
.......................> FBC & DVB-S2X into 90cm dish (27.5W) Opticum robust Unicable LNB
AX HD61, Edision Osmio 4K+, Zgemma H9Combo, Octagon SF8008 , gbtrio4k, h9se using unicable ports
Zgemma H9 C/S into Giga4K
do you have any other spare router at home? If you have try just plugging it and then connect the receiver to it via LAN cable. It doesn't need to be connected to the phone/internet. Just see if you get an ip address from the DHCP server on the router.
The networks it worked on yesterday, no longer work today. In fact it just won't work on any network today. I have tried using modem mode, home plugged through to a dlink router, fixed IP addresses, dhcp off, it's giving me nothing today.
Over the last few days, it seemed to work when the box was cold, ie: after 15 mins power down. Today I am just getting N/A again in the network settings.
yes i was asked to reflash with hades 14 from rear port and when powered up it got a connection box was off at rear switch and download plugins yes it did reboot gui and could still access plugins but if i do restart box its gone and network wizard confirms it.need other location to check further as asked.
I have now returned the box. The connection was too inconsistent for me. I checked on numerous networks with inconsistent results.
Will await the outcome from WOS but I have asked for an exchange.
Thanks everyone for the help
Hope you get sorted cactikid
cactikid (02-07-15)
one thing that worries me is how hot this box is in standby.
how long have have you had the box as mine was the 17/05/2015 ?
Last edited by cactikid; 02-07-15 at 22:54.