Cccam 2.30

[Fuzzy]

Hi
I have a legitimate Sly card so I hope I am not breaking any rules here. Before Apollo 25 I was using Oscam and Cccam 2.13 together which worked perfectly. Since Apollo 25 I have had to upgrade to Ccam 2.30, otherwise it wouldn't decrypt multiple channels. However, the old Cccam had the 256 option so I could tell it give the n:line priority. Cccam 2.30 doesn't have this option so the only way I can make Cccam use my card is by disabling the c:line.

I was going to revert back to Apollo 24 but then the feeds didn't work since that was changed after Apollo 25

Anyone any ideas please? Thanks in advance

[bellejt]

install apollo 24 manually and also Cccam manually.You don't need the feeds then. If you need image apollo 24 for DUO2, I still have that here on my hdd

[Fuzzy]

Thanks bellejt. The reason I need the feeds is because I have a usb tuner that uses the em28xx driver. Is that driver available to download manually anywhere?

[bellejt]

maybe if you change the download url to the new server

Ps: I see the driver is available in the downloads when applications download is started.Do not know where there to be find

I could sent you the files in the new image in the opkg directory if I have your Pm adress because via PM on this site thats not working

[Fuzzy]

Well if I could find the em28xx driver then I would probably go back to Apollo 24. What you suggested would be great bellejt, most appreciated

[bellejt]

just send a PM with your email adress and I sent you the zip file from opkg directory.

PS no need.Attached it in the topic.

To Forummaster : if this is not allowed pls remove the file.

[rossi2000]

why dont u ditch cccam and just use oscam?
better all round then.

[Fuzzy]

why dont u ditch cccam and just use oscam?
better all round then.

It took me ages to get my setup working properly Can I use a local card and a cline just with oscam then? If it can be done, then that's what I'll do (eventually), but I think I'll just go back to 24 for the time being.

Thanks for the advice though rossi

[Fuzzy]

I tried putting Apollo 1 on as it's the only one I have pre 25 and then over-writing the opkg files and installing em28xx but the box won't boot. It get's stuck on the VU+ page and won't go past it even after numerous power-offs. The only thing I can do is re-flash it.

I will look into using oscam alone. Ta for your help

[rossi2000]

oscam alone is the far better solution.
and does what your after perfectly.

[garyblas]

I use Oscan and occasionally CCCAM 2.2.1 which works

[bellejt]

in attach because sending om private email does not work

[Fuzzy]

Thanks very much bellejt. Unfortunately as soon as I install the em28xx driver, the box still won't boot. I assume the driver must have been updated since build 24. I may as well go back to Apollo 64 as I can't get my usb tuner to work in anything before 25 anyway. I will have to configure oscam to be used alone. Cheers for your help