does the 102e need an image?
Downloaded latest firmware via internet. Do I need to flash box, cant login to box via ip address, so cant find cccam, I am lost and cant find any answers.
bought from forum sponsor.
anybody?
does the 102e need an image?
Downloaded latest firmware via internet. Do I need to flash box, cant login to box via ip address, so cant find cccam, I am lost and cant find any answers.
bought from forum sponsor.
anybody?
okay put on patch via usb found cccam
what do i put where, used to using dcc
This is not a linux box, you do not use DCC, read the stickies http://www.world-of-satellite.com/sh...hey-are-to-use!
D I S C L A I M E R
My right to post information is protected under the rights for freedom act. In all instances, information discussed here on my posts are either hypothetical in nature, out of general curiosity, common knowledge, public knowledge, or role-play. Any use of the collective descriptions and shared knowledge from any of my posts are at the sole discretion of the reader. I am not responsible for what you do with it!
Please help keep OpenViX online, donate HERE.
Rules can be found HERE
Support our sponsor World-Of-Satellite HERE
GIGABLUE UHD QUAD 4K, VU+ DUO 4K SE, ZGEMMA H7S, VU+ UNO 4K SE
Triax 1.1m Powered by TM2600, Fixed 28.2 Zone 2 dish with GT-SAT Unicable
i have, thats how i got as far as i did, will look again, cheers
created file in notepad, saved as necessary in folder flash config, allshares.dat, put usb in front slot chose usb, flash config, allshares.dat, start and just sits there saying do not remove usb?
stuck or am I missing something
Easiest way is to either setup in network settings or web interface. Just go to IP address of your receiver in your browser
going up for sale, give up, thought could use like dreambox/technomate, but cant suss it. hohum.
hahahaha cant believe it, left it and went back to it and its up and running, I was very slow.
For The Setup Of NewCamd Just Enter The IP Address Of The Box Into A Browser Window... Then Select The Module Tab... And Enter The URL(Address), Port Number, Username(Login) And Password And Tick The Auto Connect Box... Just That I Was Trying For Over An Hour Trying To Use The allshares.dat File Via USB Stick... And When I Logged In Onto The Web Interface, I Noticed That All The Information Was There, But The Auto Connect Box Wasn't Ticked... As Soon As I Ticked It, The Box Descrambled The Channels... I've Posted This In Case Anyone Else Has The Same Problem...
keyno (19-12-12)