I've started to see posts with members having problems using their external USB hard drives, so thought I'd put to the test a post a quick guide.
For the purpose of this I'm using a portable 2.5" USB HDD with its own power supply. The HDD is a Hitachi 250GB SATA. It's very important that the external HDD has its own electric power supply.
Guide below: -
1. Connect to a windows PC. Go to control panel > Administrive Tools > Copumter Management > Storage > Disk Managment > Select you USB HDD, right click on it and select 'Delete Volume'. Make sure that its your USB HDD that your deleting!
2. Connect to Solo, power up the HDD then reboot your Solo.
3. Once rebooted press Menu on your remote > Setup > System > Harddisk > Initialization > Click ok on the selected HDD
4. On the next screem press Red Button to initialize and wait for it to complete.
5. Go to your PC, open a command promt and telnet to your Solo. As follows: -
Code:
Telnet 192.168.1.11 <<<<Use your Solo IP
Code:
Password = leave blank, just press enter
6. Now create a folder in /media/usb for recording. We'll call it movie.
Code:
mkdir /media/usb/movie
7. Close the command prompt and go back to your Solo.
8. Press Menu > Setup > System > Recording paths > Highlight Defualt movie location, see below: -
9. Press ok, then you come to a select location screen. You will see the default at the bottom is /hdd/movie. We need to change this. Press menu on your remote and select 'switch to filelist'. Now navigate to /media/usb/movie, do not click ok on movie, just highlight it and press Green button to save the location. You now have something like this: -
10. Do the same for Timeshift location, but just choose /media/usb
Thats it done
Enjoy your recording with your shiney new baby VU+ Solo