I am running remote channel stream converter between an Xtrend ET10000 master and an ET 7000 slave. After stupidly updating Openvix to 5.1.11 on the slave, I am unable to reinstall the remote channel stream.

I can see the ET10000 when I browse the network with the ET7000 slave and I have inputted the same IP number into the remote channel stream interface. The ET10000 does not have a password, so I have left this blank. I have left all the other entries at their default values. (host user name “root”, host streaming port “08001”, host FTP port “00021”.

When I reboot after going into client mode and entering the IP address of the ET10000, the ET7000 seems to hang up. I gave it about 10 minutes, but nothing happened except the wait message and the moving “Vix” sign. This repeats. The only way out seems to be to reflash.
Rebooting the client without going into remote channel stream converter works OK.

Does anyone know what I am doing wrong, or have suggestions?

Many thanks.