That's my first post so welcome everyone
It's also my first linux based receiver so the questions I have are probably noob-style
I've just received my shiny Solo2 from World-of-Sattelite.com and with a help of many forums I was trying to set it up.
On the paper it didn't loook too bad but ....

Solo2 is for now connected to sky dish, two signals (I'm waiting for motorised dish)
I am trying to use my Sky card in Solo (Movies, Sport and HD)
I have Vix software preinstalled, I managed to install Cccam and with empty config file I can watch FTV channels.
Than I tried to change settings in Ccam.
I have two lines in cfg file
BOXKEY: /dev/sci0 xx xx xx xx
SMARTCARD CLOCK FREQUENCY: /dev/sci0 3570000
Boxkey is from my sky box in hex - but nothing happens. Still no HD channels from SKY
I would rather not touch Oscam as it looks even more complicated for me to config.
If Oscam is my only route is there any copy and paste config for Sky that I could use?

Another problem I have is network. Solo 2 is connected by wire to my router. I know its IP but when tried to use vucc I have Access denied error.
Ping is fine, at the end I used Windows to send config file to the receiver.... but why it doesn't work with VUCC?

I am sure I will have more questions later...
Thx
Thomas