Hi all,

Just received an xp1000 preinstalled with vix from the site sponsor. The box boots with the spinning vix and then comes to the screen for select hdmi input. At that point I cant do anything and a few seconds late it reports a software error and then reboots. This continues in a loop. It says to check the error log on the hdd (usb flash drive) but there is no error log.

Please help.

Note: I have a solo2 with vix so I do know a little about them,although not a lot.


Edit: I have also downloaded vix to a usb stick to try and flash it but the instructions say to wait on the 2 red lights and then press ch+. I dont get 2 red lights, just 1 and then the power button goes purple then blue eventually??

Thanks

skooby