Triax 4 way lnb holder

[deltec]

I have a vu ultimo and was wandering if any boday was using a 4 way lnb holder how do I set these up any advice

[abu baniaz]

Please always add the 4K to your receiver description. The ultimo is one receiver, the ultimo 4K is another receiver.
If you have a four port diseqc switch, you would set up the tuner with the wire from the diseqc switch a follows:

Simple
Diseqc A/B/C/D
Port A = Change to the satellite THE LNB is pointing to. Only you/installer know that.
Port B= Change to the satellite THE LNB is pointing to. Only you/installer know that.
Port C= Change to the satellite THE LNB is pointing to. Only you/installer know that.
Port D= Change to the satellite THE LNB is pointing to. Only you/installer know that.

[deltec]

So I just need one wire from the dish is that right

[bellejt]

one wire /switch /tuner

[abu baniaz]

So I just need one wire from the dish is that right

With regards to how to set the tuner: You set the tuner to match the hardware connected to it.

You have Duo 4K with an FBC tuner and a legacy twin input satellite tuner if I remember correctly. If you can draw a picture of what you have in terms of LNBs, number of ports, dish, we can advise better. A diseqc switch will allow you to select one satellite only from that cable. So more cables may be better. If a picture is too much work, record a video and upload it

[deltec]

So all I need 4 lambs then just wire them to my vu ultimo then I’m away is that right

[deltec]

I have a blank lmb in the ultimo will I need to by a lmb for the 4way lnb holder thanks deltec

[abu baniaz]

Please post a screenshot of following screen:
Menu > Information> Devices

Then also post a picture of the wires at the back of the receiver.

And which satellites do you want to receive on your 4-way LNB holder.

[deltec]

Do u mean menu information tuners. Is that right

[deltec]

I have 28 east I want to get 39 east 23 east 13 east and 1west

[ronand]

Then you will need a motorised dish or several dishes - that can't be done with a 4 way holder.

[deltec]

No. I don’t if u read it

[Joe_90]

No. I don’t if u read it

You didn't read the specifications properly - 20 degree max spacing between the extreme ends of the bar holding the LNBs. So - 39E, 28E and 23E is possible, but not 13E. Or, - 13E, 23E and 28E, but not 39E. 1W is too far away from even 23E. As @ronand wrote in post #11 - you need a motorised dish or several dishes. Or, maybe a Wavefrontier toroidal T90 dish (if you can find one)? This can cover up to 40 degrees of separation. But, you'd want to have lots of cash and lots of experience!

[deltec]

I’ll see if the dish wants tweaking I can’t get every thing I used to get strange one