Tracking down what is going on has been challenging - the problem has surfaced since installing the latest firmware.

The setup it basically Solo 2 -> Anthem 50V A/V processsor -> Elson 9300 projector.

I was blaming the Logitech remote but it is nothing to do with it. If I manually power the Solos 2 to standby by touching the front, it appears to somehow send as signal to the projector to power it to standby. Turning the Solo 2 ON from standby does NOT affect the projector, only powering it off affects the projector. I have two other Vu+ units (A Duo and Ultima) and no such problems exist with them and the current problem only occurred after installing 6.2.008.

How a signal from the Solo2 can power the Projector to standby is a mystery - it has nothing to do with IR codes, it is caused by Solo2 with the latest firmware.

PLEASE HELP!!

TIA

John