Hi,
Is there anyway to reset a Technomate motor without going up a ladder please?
I've been looking around and see screenshots of the older non E2 Technomate receivers which seemed they could do it, but is there a way to reset the motor from OpenVIX please?
Basically mine seems stuck on 28.2 (lucky as otherwise the wife would kick off).
The motor shows a green light and flashes orange when you try and move it within OpenVIX but it doesn't physically move. It's set up as USALS with all the co-ordinates as they used to be when it worked fine.
I had a coming together with a train at the backend of last year so still not able to get up the ladder to do a physical reset, so wondered if there was anything else I could do remotely please or whether it's just stuck as is until the physical reset is attempted.
I've seen posts saying it could be a loose cable etc, I'm just wondering if there's anything I can do from this end while I can't get up the side of the house.
With thanks in advance!