Any help appreciated.
I have a tchnomate box with vix image. How do I set the tuner and bouquets up for freeview?
Thanks in advance.
Any help appreciated.
I have a tchnomate box with vix image. How do I set the tuner and bouquets up for freeview?
Thanks in advance.
Reference web page at
First, set up your tuners as in image 1 in the web page link [Menu -> Setup -> Tuner config -> and for each of your terrestrial tuners]Code:http://www.admac.myzen.co.uk/E2_scan/
Note: In the tuner set-up set the region to UK all regions (Europe DVB-T/T2) and NOT a specific UK region/transmitter
Make sure that you set T2 and not T - T2 gives you both SD and HD channels.
For each tuner PRESS GREEN to save setting
Second, menu -> setup -> EPG -> Graphical EPG -> Show Bouquets on launch = yes
PRESS GREEN to save setting
Third, set up AutobouquetMaker as in image 2 - freeview section [Menu - Setup -> Tuner Configuration - AutoBouquesmaker -> Providers]
Notes: I have both satellite and Terrestrial tuners so the AutobouquetMaker page shows both Freesat and Freeview - you can ignore the Freesat settings and say no to them.
My transmitter is Bluebell Hill - you need to select your transmitter from the list - highlight the Freeview uk: area option and use the > button on the remote to go through the list.
PRESS GREEN to save setting
Press Green to scan (or select start scan)
menu -> setup -> EPG -> settings -> Enable EIT EPG -- this should populate the Freeview EPG from over the air data - it may take a few minutes to populate the first time you use it.
PRESS GREEN to save setting
Press the guide button on your remote.
This should get you working but there is a lot more you can do to configure or change to get a better looking program guide - re-arranging channels, deleting junk channels etc.
If you don't get the HD channels on your transmitter post back.
Last edited by adm; 18-09-17 at 19:43.
Xtrend ET10K, 2 x satellite tuners 28.2 (Sky FTA), 2 x hybrid (UK Freeview), Zgemma H9S (satellite)