Hi, My Vu2 Solo2 froze due to a faulty LNB.
After the new LNB was fitted and checked for correct working using my backup Sab receiver, the Vu2 Solo2 booted but then froze at the Vix splash screen where it remained for 1 hour.
I rebooted and tried to install a backup image but no success - same freeze occurred.
Downloaded a recent image from Vix (openvix-5.0.020.release-vusolo2_usb) and flashed the box according to instructions on forum.
After re-scanning channels, etc during setup, all seemed to be going to plan but when I tried to save and exit the setup routine the screen displayed a message saying there was a software fault.

I was able to upload a crash log to Vix (acknowledged to me by email) but did not get my own email copy as expected from the system.

I don't know if the LNB fault had anything to do with the problem - or did my Vu2 box die??

Any ideas please?