Goal of this video tutorial is to teach you how to install tvheadend and scan Satellite DVB-S/S2 channels on WeTek Play with OpenELEC.
Usually, when scanning channels with tvheadend it is enough to create Satellite (Network), and to choose from list of Satellite, Satellite at which your antenna is aligned.
For example, when creating Network (Satellite), and your Satellite dish is tuned to Astra 19.2E, you will only need to select 19.2E Astra from list of Satellites.
After you finished creating network, assign this network to one of two DVB-S2 adapters, and enable it.
When scanning is done, click on Services tab, and then click on Map All button, from where you can map all channels which will be available on your OpenELEC installation.
For easy setup, take a look at our tutorial on YouTube:
How to configure DiSEqC 1.0 or 1.1 with tvheadend:
Hello Guest, if you are reading this it means you have not registered yet. Please take a second, Click here to register, and in a few simple steps you will be able to enjoy our community and use our OpenViX support section.
