Lets us know what happens after the flash of firmware.
Lets us know what happens after the flash of firmware.
D I S C L A I M E R
My right to post information is protected under the rights for freedom act. In all instances, information discussed here on my posts are either hypothetical in nature, out of general curiosity, common knowledge, public knowledge, or role-play. Any use of the collective descriptions and shared knowledge from any of my posts are at the sole discretion of the reader. I am not responsible for what you do with it!
Please help keep OpenViX online, donate HERE.
Rules can be found HERE
Support our sponsor World-Of-Satellite HERE
GIGABLUE UHD QUAD 4K, VU+ DUO 4K SE, ZGEMMA H7S, VU+ UNO 4K SE
Triax 1.1m Powered by TM2600, Fixed 28.2 Zone 2 dish with GT-SAT Unicable
Will do... didn't have a flash drive yesterday... will buy one today
I cannot get the box to flash. Formatted a USB pen drive to FAT32, unzipped the files from the FINISH folder only and did not unzip the vmlinux folder. Put the files on the root of the USB pen drive. First I just powered off the box by the remote, put the USB pen drive in and turned it back on...nothing. Then I powered it off at the wall put the pen drive back in and then powered back on at the wall... nothing. Just turns on like normal. Am I doing something stupid?
Try using this HP format tool to format your USB stick http://www.world-of-satellite.com/sh...SB-Format-Tool
D I S C L A I M E R
My right to post information is protected under the rights for freedom act. In all instances, information discussed here on my posts are either hypothetical in nature, out of general curiosity, common knowledge, public knowledge, or role-play. Any use of the collective descriptions and shared knowledge from any of my posts are at the sole discretion of the reader. I am not responsible for what you do with it!
Please help keep OpenViX online, donate HERE.
Rules can be found HERE
Support our sponsor World-Of-Satellite HERE
GIGABLUE UHD QUAD 4K, VU+ DUO 4K SE, ZGEMMA H7S, VU+ UNO 4K SE
Triax 1.1m Powered by TM2600, Fixed 28.2 Zone 2 dish with GT-SAT Unicable
OK managed to flash it with a different USB stick. Went through the setup wizard and got to the network bit and it couldn't connect to the internet. The light on the router still does not come on and no lights flash on the gigablue's ethernet port either. Is it time to ring world-of-satellite up and tell them I think I have a faulty box?
The box was faulty. The sponsor is sending me a new one... great customer service