will not read card

[Rob van der Does]

Wont work with an empty config, the webif needs to be set.

Works here, never been any different.
And also when my configs are filled in, there no webif-setting in it.

[lost_one]

Thanks for everyone's help and patience with this. I got it working today, I'm a complete dumba$$. The card wasn't inserted far enough in the slot. (At least I can admit it!).

[Sicilian]

Thanks for everyone's help and patience with this. I got it working today, I'm a complete dumba$$. The card wasn't inserted far enough in the slot. (At least I can admit it!).

[lost_one]

I'm ready for all of these! The funny thing is, I've been working on electronics for 20+ years, and usually it takes a delicate hand, not an iron fist. It felt like the reader was going to break off the board with the amount of force I put on the card. (I'll use a bigger hammer next time!)

[Rob van der Does]

(At least I can admit it!).

Good indeed: many can't/won't

[Zartmy]

Agree with the above, to check press blue CCcam Info > Entitlements.


Wont work with an empty config, the webif needs to be set.

I had to add the following line in CCcam.cfg to get the webif to work

ALLOW WEBINFO: YES

[Rob van der Does]

I had to add the following line in CCcam.cfg to get the webif to work

ALLOW WEBINFO: YES

I can't believe that: works here and has always worked without any line in CCcam.cfg

[Larry-G]

same here rob. i have never had to use that line to use the web interface with CCcam in the past, although it's been a while since i tried as i now just go through the blue button and do it that way.

[Zartmy]

I can't believe that: works here and has always worked without any line in CCcam.cfg

You dont think that depends on which package of cccam you install ? Anyway if I have a blank CCcam.conf and uses the vix softcam manager i get a popup when using some functions telling me to add that row to CCcam.cfg