Unicable setup help

[scouse645]

just received a GT-Sat GT-S1DCSS24 SCR/dCSS Single Cable Unicable II LNB SCR24 from w/o/s shop, i need some help to setup the tuners on my gigablue quad 4k with 2xDVB-S2X FBC tuners, i need to know what settings i need in each tuner A-H. just to add i have a cable connected to A and B tuners.

[abu baniaz]

have you read the thread in Unicable section?

You can select the "dnb hello" model.

[scouse645]

Thanks, i have been reading a few bits about it, i just needed to know if i need to repeat the setup for every tuner? it doesn't seem to work with dlnb dhello selected.

[twol]

just received a GT-Sat GT-S1DCSS24 SCR/dCSS Single Cable Unicable II LNB SCR24 from w/o/s shop, i need some help to setup the tuners on my gigablue quad 4k with 2xDVB-S2X FBC tuners, i need to know what settings i need in each tuner A-H. just to add i have a cable connected to A and B tuners.

SO whats on the end of the 2 cables? 2 LNB‘S or 1 cable from a LNB and then split or??

[scouse645]

1 cable from LNB and then split.

[Willo3092]

This is how mine is set up

Tuner Setup.jpg

Tuner A.jpg

Tuner C.jpg

[scouse645]

This is how mine is set up

Tuner Setup.jpg

Tuner A.jpg

Tuner C.jpg

That lnb model number is not working on mine.

[scouse645]

The only one to work is GT-S1-2-3SCR4 but it only has 4 user bands.

[Sicilian]

The only one to work is GT-S1-2-3SCR4 but it only has 4 user bands.

GT-S3DSSR24 should work fine. Uses same userbands as the LNB you have.

[scouse645]

Thanks, been trying it for a while on the one you mention but it's not working for me. i just get tune failed message.

[abu baniaz]

Every tuner needs to be configured to make full use of the LNB. If you don't configure it, it will be in FBC Automatic, i.e loop through mode.

Attach the file called "settings" in /etc/enigma2 You will need to zip it.

[Sicilian]

I've had times that after setting all 8 tuners receiver needs a reboot. Menu > Standby & Restart > Reboot.

[scouse645]

Every tuner needs to be configured to make full use of the LNB. If you don't configure it, it will be in FBC Automatic, i.e loop through mode.

Attach the file called "settings" in /etc/enigma2 You will need to zip it.

Thanks, i can see the file but i haven't a clue how to Attach it. just a though, the original lnb i sent for was discontinued, so they sent me the new one.

[Sicilian]

One thing, please don't take offence to this, but make 100% sure you're using the Unicable output on LNB. You just need one cable feed to Tuner A, then follow the guide mentioned above.

[scouse645]

no offence taken, i will check it now to be sure.