yes mate,done that,i put a bootloader 1.0.3 on it and arthur image from 14.5.11 on one of the usb disks and it still doesnt get past the booting up screen
yes mate,done that,i put a bootloader 1.0.3 on it and arthur image from 14.5.11 on one of the usb disks and it still doesnt get past the booting up screen
Try official Duolabs firmware.
D I S C L A I M E R
My right to post information is protected under the rights for freedom act. In all instances, information discussed here on my posts are either hypothetical in nature, out of general curiosity, common knowledge, public knowledge, or role-play. Any use of the collective descriptions and shared knowledge from any of my posts are at the sole discretion of the reader. I am not responsible for what you do with it!
Follow us on Twitter 0penViX
Rules can be found HERE
Support our sponsor World-Of-Satellite HERE
GIGABLUE UHD QUAD 4K, AX HD61 COMBO, ZGEMMA H9 TWIN, VU+ ULTIMO 4K
Triax 1.1m Powered by TM2600, Technomate 80cm Powered by TM-2600 and Fixed 28.2 Zone 2 dish
tried that as well mate,no joy,can i flash with a serial cable or dont you think thats the problem,just wont get past the boot up screen
Probably best to contact the retailer you bought it from now you have exhausted all routes to get the box working
All PM,s asking about c/s on cable will be ignored and reported to forum staff!