SF 8008 tuner configuration

[bmitie]

Jrc11 if you could tell me the image and skin you are using I can have same on my box, you dont do a reflash to configure tuner, its a case of menu setup tuners etc then you set tuner. you had diseq in the past but USALS is better and easier you you need a motorised sat list in the box.

[abu baniaz]

@jrc11
What image are you using at the moment. Name and version/date please

You should find details by selecting something like
Menu, Information, About

Show a screenshot/picture of the tuner configurations please.

[JRC11]

I have just done another reboot. Have got Open Vix this time. . I think the tuner is configured. However it is only configured for a single satellite. bellejt, I do not have the word rotor on my tuner configuration screen. bmitie my box is not remote from my PC. Feeling thoroughly fed up I have had enough for today but may try again tomorrow. I am too old to get my head round this.

[bellejt]

https://www.openvix.co.uk/openvix-bu...20Vs%201.1.pdf


1.2.1

[abu baniaz]

Please stop jumping around images as you will get even more confused.

Which exact version of ViX have you booted into?
Post a picture of your tuner configuration.

[bellejt]

rotor = positioner

[ArloGuthrie]

I have read the manual before. See some "assumptions", and therefore details are left a bit lacking.
USALS settings are kind of skipped but hints are on pg. 9,10.
If the OP could list the satellites desired to be received it may help.
Notice the Advanced setting in Tuner Setup.
Could you verify that your install is configured as receiver>dish mover>lnbf please? And if not detail it for us.
And yes. Once we stay with ViX and get you working. Setting up other images will make sense and be easy.