Technomate TM-Twin 4K Boot Up
Hello Guys
First time poster and very much a novice but hoping someone can help.
I bought a TM-Twin 4K from an eBay retailer who has gone black and I cannot get in touch with him.
The receiver boots up with the technomate screen and then goes to the World of Satellite screen and the VIX rotating in the top left corner.
It boots up to around 37% to 49% and then just continuall flashes screen. The green light flashes on/off during the whole process.
At this point it continually rotates the VIX logo and flashes green light. I cannot do anything with the receiver at all.
I have tried to reeflash the latest VIX patch on a clean formatted pen drive (8gb) but this doesn't work.
I have tried going back to previous patches and tried this but it fails.
I think the software that was installed has somehow fried the machine.
Is there anyone who can suggest anything?
Bear in mind, I cannot get the receiver to connect to my network by wifi either as I haven't been able to use the receiver or any set ups.
Any suggestions greatly appreciated. Technomate Support was useless at best.
Many thanks!
[I have just purchased a Zgemma H7S from World of Satellite which is due to be delivered tmw as I fear the worst from the Technomate]
Hello Guest, if you are reading this it means you have not registered yet. Please take a second, Click here to register, and in a few simple steps you will be able to enjoy our community and use our OpenViX support section.
Reply With Quote
