Hello Guest, if you are reading this it means you have not registered yet. Please take a second, Click here to register, and in a few simple steps you will be able to enjoy our community and use our OpenViX support section.
Page 2 of 2 FirstFirst 12
Results 16 to 20 of 20

Thread: AutoBouquetsMake 3.1 Cannot Read Data

  1. #16

    Title
    Junior Member
    Join Date
    Jan 2016
    Posts
    10
    Thanks
    0
    Thanked 2 Times in 2 Posts
    No Splitters, 20mt run of original Sky twin shot cable

    Tuner A Scan results below

    Tuner A Single Sat Manual Scan.jpg

  2. #17
    abu baniaz's Avatar
    Title
    Moderator
    Join Date
    Sep 2010
    Location
    East London
    Posts
    23,338
    Thanks
    6,421
    Thanked 9,146 Times in 6,224 Posts
    That's the right number of services to find, so your dish alignment is fine although LNB ports are independent. However, you have swapped cables round so that rules out the LNB being faulty. lathough you do get odd weird switching faults. You could try at a friends house if you want to rule this out too. Make sure they don't have a Sky Q LNB.

    Sorry to ask, but did you try the scan of tuner B with it disabled or enabled? And what have you configured it as? If tuner B is not finding services when enabled and correctly configured, best to speak to your seller.

  3. #18

    Title
    Junior Member
    Join Date
    Jan 2016
    Posts
    10
    Thanks
    0
    Thanked 2 Times in 2 Posts
    Have 2 dishs running and getting same on both. Tested with a VU+Duo & zgemma H2 and working fine on both dishs.

    Tuner B was enabled (Set to = Tuner A)

    Looking like faulty B Tuner ?
    Attached Images Attached Images
    Last edited by kiltoom; 22-09-19 at 00:17.

  4. #19
    abu baniaz's Avatar
    Title
    Moderator
    Join Date
    Sep 2010
    Location
    East London
    Posts
    23,338
    Thanks
    6,421
    Thanked 9,146 Times in 6,224 Posts

    AutoBouquetsMake 3.1 Cannot Read Data

    Looks like issue with tuner B. I prefer to manually set tuner instead of equal to.

  5. #20

    Title
    Junior Member
    Join Date
    Jan 2016
    Posts
    10
    Thanks
    0
    Thanked 2 Times in 2 Posts
    Has tried both ways, Thanks for help

Page 2 of 2 FirstFirst 12

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
This website uses cookies
We use cookies to store session information to facilitate remembering your login information, to allow you to save website preferences, to personalise content and ads, to provide social media features and to analyse our traffic. We also share information about your use of our site with our social media, advertising and analytics partners.