Saorsat - Failed to tune Saorsat on tuner B

[Huevos]

Please provide a proper debug log with extra debug enabled.

[Xiaomi]

Okay - is the process I followed in post #11 correct?

[Huevos]

So far so good...

Now we need a proper debug log. Follow the instructions here:
https://www.world-of-satellite.com/s...l=1#post348520

And here (for extra debug):
https://www.world-of-satellite.com/s...l=1#post406166

Put the log in a .zip file and attach it.

[abu baniaz]

You have a PM.

[Xiaomi]

Reran tonight. Log files attached.
The only mod I've made was to change the Tone Mode from Band to Off.
Still using a direct feed from the LNB bypassing the switch and 28.2E.

Enigma2_debug_2019-04-19_22-43-48.log
abm.log
lamedb.txt
lamedb5.txt

[Xiaomi]

Sorry, seen your pm last night. I'm out and about away from the house at the minute, but I'll send the address when back

[Huevos]

https://github.com/oe-alliance/AutoB...fcddb42f7c7d03

[Xiaomi]

Great - that worked perfectly. Satellite is now correctly picked up as 9.0E Ka-band instead of the Ku-Band which was previously picked up.
I'm re-introducing 28.2. Hopefully, I'll get past the fail to tune Saorsat on Tuner B message.

[Xiaomi]

All working perfectly now - including the custom mix file switching out the 28.2 channels for the 9.0E equivalents.

Thank you both for your help in getting this setup. It has been a long process, but I know my parents will be very grateful for your perseverance.

[Xiaomi]

Ok, That is the opposite to convention. Why would Inverto do something so stupid? This is why Voltage Mode will not work polarisation and why your switch needs the LNB plugged in the wrong port.

With a normal LNB when you insert the dielectric plate "vertical" becomes "RHCP". This has nothing to do with the wiring, but just that the plate is inserted.

Hi - I'm having an issue obtaining Saorsat again on OpenVix on a Mutant HD51. Had some work done at house and there is an issue reconnecting this for my parents. The predefined transponder does not pick up a signal. When I change to Vertical - or even Right Circular, it is now working.
I think that the issue with my setup is where I've connected the satellite feed into the multiswitch and is directly related to the above reply from @Huevos.


28.2E fed into Port A of an EMP-Centauri Multiswitch.
9.0E fed into the Vertical Low input of Port B of the Multiswitch. All Saorsat is on a single transponder, so a single input is sufficient. Should I be changing this to one of the Horiztonal inputs or do I need to update the transponder settings in the Satellites.xml?

Thanks.