"No signal" message, receiver loses settings.

[spiderman01]

Hi there,

Very seldom I get the"no signal" message and I am left with no picture. After going through a lot of fault finding, I went to tuner set up, where I have: Tuner A: not configured (one coaxial to tuner B with a motorized system) and Tuner B: Positioner USALS. I selected Turner B and all looked good so I saved the settings and vuala!!!! Suddenly we had picture. It seems like the system didn't apply the settings. Does anybody know why this could happen? Thanks.

[spiderman01]

Does anyone know anything??

On my other receiver, VU+ Solo 2, I can't watch certain channels because I lose my internet connection, then I recover it by changing Nameserver from 8.8.4.4 to 0.0.0.0 or viceversa.

Again, it seems like the system is not remembering the settings or it's not storing them. Does it happen to anyone?

Sent from my Redmi 5 Plus using Tapatalk