Hello Guest, if you are reading this it means you have not registered yet. Please take a second, Click here to register, and in a few simple steps you will be able to enjoy our community and use our OpenViX support section.
Results 1 to 3 of 3

Thread: Startup Channel

  1. #1

    Title
    Junior Member
    Join Date
    Jul 2014
    Posts
    14
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Startup Channel

    Hi.
    When I bring the box out of Standby there is no channel selected, just " ---- " on the front display, and a "no signal" message on the TV. If I up, or down shift channel on the remote it comes up, but not on a channel anywhere near the pre-set Startup Channel.
    Any suggestions much appreciated.

  2. #2

    Title
    ViX Beta Tester
    Join Date
    Jan 2011
    Posts
    14,099
    Thanks
    3,389
    Thanked 4,102 Times in 3,198 Posts
    Your 'pre-set Startup Channel' no longer exists on that frequency?
    How are you shutting down your box?

  3. #3

    Title
    Junior Member
    Join Date
    Jul 2014
    Posts
    14
    Thanks
    0
    Thanked 0 Times in 0 Posts
    I've simply been pressing Standby on remote. I've tried changing the startup channel with the same result. I've just re-scanned all the channels after the box has been idle for 12 months and this problem has arisen. But I can see your logic, I'll try again, and maybe I can revert to no startup channel and see if that makes a difference. Will report back.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
This website uses cookies
We use cookies to store session information to facilitate remembering your login information, to allow you to save website preferences, to personalise content and ads, to provide social media features and to analyse our traffic. We also share information about your use of our site with our social media, advertising and analytics partners.