Hello Guest, if you are reading this it means you have not registered yet. Please take a second, Click here to register, and in a few simple steps you will be able to enjoy our community and use our OpenViX support section.
Results 1 to 1 of 1

Thread: Illustrated Guide to setting up disqec 1.1(T90 dish with multi LNB Vix image)

  1. #1
    afterburn's Avatar
    Title
    Forum Supporter
    Donated Member
    Join Date
    Aug 2014
    Posts
    259
    Thanks
    138
    Thanked 29 Times in 18 Posts

    Illustrated Guide to setting up disqec 1.1(T90 dish with multi LNB Vix image)

    At this stage you should already have your lnbs locked on the desired satelites. I am using a 10 to 1 switch
    Connect the output to your receiver
    Connect your LNBs to your switch,
    carefully noting which LNB is connected to which input. I suggest a pen and notepad for this. Right that's the hardware sorted.
    Attachment 43540Attachment 43538Attachment 43541Attachment 43539


    Now turn on your receiver and configure your tuner.
    Menu -> setup-> service searching->Tuner configuration->Select Tuner A or B whichever one your switch is connected to.
    Attachment 43544 Attachment 43545Attachment 43547

    CONFIGURATION =ADVANCED
    SATELLITE (select the desired satellite from the list)
    LNB = (select the lnb it is connected to)
    PRIORITY = AUTO
    LOF = UNIVERSAL LNB
    VOLTAGE MODE = POLARISATION
    INCREASED VOLTAGE = NO
    TONE MODE= BAND
    DISEQC MODE = 1.1
    FAST DISEQC = NO
    TONEBURST = NONE
    DISEQC 1.0 COMMAND = NO
    DISEQC 1.1 COMMAND = INPUT (select the lnb input you selected above)
    DISEQC 1.1 REPEATS = NONE
    SEQUENCE REPEAT = NO

    do the same for each satellite changing only the satellite and the LNB number it is attached to on your switch, as follows!!
    Attachment 43551

    Now you press the green button to save your settings and exit out....
    Select your tuner in this case tuner A select automatic scan and your receiver will scan all the connected satellites.
    If you get this far then you should have cracked it! the first and last screenshot of the satellite settings are at the bottom of the post for some reason, perhaps the mods might tidy this tutorial up a bit.
    Attached Images Attached Images

  2. The Following 5 Users Say Thank You to afterburn For This Useful Post:

    abu baniaz (06-12-15),dniestre (11-06-21),drowzee1872 (16-07-15),Rabmcg (04-10-16),tanis (29-05-18)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
This website uses cookies
We use cookies to store session information to facilitate remembering your login information, to allow you to save website preferences, to personalise content and ads, to provide social media features and to analyse our traffic. We also share information about your use of our site with our social media, advertising and analytics partners.