johnviv
19-05-11, 12:30
hi has any body found a solution to this problem below
the text is taken from the official www.blademedia.tv web site
i cant get to work, it only wants to record one channel,
thanks.
To perform multi-record, it is recommended that you use a fast USB storage device eg. USB2.0 Hard Drive. USB flash sticks may not give good performance, will be slow interacting, may make the box unstable or may not work at all, but you can try it.
To multi-record, press OK to show Channel List..... Press REC button on remote to start recording.... go to another channel on the same transponder.... press REC again (you may get "Record Full" message if USB is busy or slow, just try it again after a few seconds).... You now have two channels recording and you can now select a third channel on the same transponder to watch.
the text is taken from the official www.blademedia.tv web site
i cant get to work, it only wants to record one channel,
thanks.
To perform multi-record, it is recommended that you use a fast USB storage device eg. USB2.0 Hard Drive. USB flash sticks may not give good performance, will be slow interacting, may make the box unstable or may not work at all, but you can try it.
To multi-record, press OK to show Channel List..... Press REC button on remote to start recording.... go to another channel on the same transponder.... press REC again (you may get "Record Full" message if USB is busy or slow, just try it again after a few seconds).... You now have two channels recording and you can now select a third channel on the same transponder to watch.